MiniTorque.com banner

1 - 4 of 4 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
Ok so this is where I’m up to so far.
- Forge intake pipe fitted
- ITG air filter fitted
- GTT OCC on order, fitted next week
- Forge boost pipe on throttle body side. Being fitted next week
- scorpion cat back, un resonated exhaust. Being fitted next Friday
- DMS remap booked for next Friday after exhaust fitted

Hoping for 250 BHP 😎
 

·
Registered
Joined
·
19 Posts
Discussion Starter #2
So I made 238bhp and 265 ft lbs. a very hot day and was getting a lot of heatsoak so ordered an Airtec intercooler that arrived yesterday and booked in to be fitted next Friday. I will be back on the dyno soon for the map to be optimised and a new power run. Will let you know know how it goes
 

·
Registered
Joined
·
3,673 Posts
So I made 238bhp and 265 ft lbs. a very hot day and was getting a lot of heatsoak so ordered an Airtec intercooler that arrived yesterday and booked in to be fitted next Friday. I will be back on the dyno soon for the map to be optimised and a new power run. Will let you know know how it goes
Dms maps are optimistic to say the least, get yourself a manic
 

·
Registered
Joined
·
19 Posts
Discussion Starter #4
It was done on the dyno so I saw the before and after figures and the car stayed on the dyno while the programming was done. I’m booked in for the map the be optimised on Tuesday as I’m having an Airtec intercooler fitted tomorrow as I was getting quite a bit of heatsoak. I’m hoping for 250+ then ��
 
1 - 4 of 4 Posts
Top