MiniTorque.com banner

1 - 20 of 39 Posts

·
Premium Member
Joined
·
397 Posts
Discussion Starter #1
Finally I'm finishing this project , just waiting for an m7 bigger scoop and front aero bumper with carbon splitter and the car is ready for track days!



Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
397 Posts
Discussion Starter #6
What's with the ballast resistor on the drivers front by the bonnet catch?
It's a common fault with these pre facelift Ines, it's for the radiator! So the fans won't stop working again! It's for the remote can control as well . The rads fans a bit bigger on mine , so sometimes I do it on auto and sometimes when on santa pod I do it on manual!


Sent from my iPhone using Tapatalk
 

·
Learning!
Joined
·
5,803 Posts
Yes I did. Just need to finish it off and that's it! It's almost ready but not quite yet


Sent from my iPhone using Tapatalk
Seems like a lot of effort mate, you're obviously intending to sell it complete?

stating the obvious it would fetch more parted out
 

·
Premium Member
Joined
·
397 Posts
Discussion Starter #10
Seems like a lot of effort mate, you're obviously intending to sell it complete?

stating the obvious it would fetch more parted out
Naah, I normally modify cars , try and test them out and then sell it off and move to the next one . I want someone else to enjoy it. I hate to brake it for parts, but thanks


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
397 Posts
Discussion Starter #18
When you selling it lol
Next month mate! Just had all these carbon dipped parts fitted and waiting for the Gp bumper to be fitted and wanna try it with an aero one too!

Gp wing , atomspeed scoop and the rev gauge rings




Sent from my iPhone using Tapatalk
 
1 - 20 of 39 Posts
Top