MiniTorque.com banner

61 - 80 of 463 Posts

·
Registered
Joined
·
435 Posts
Nice car dude Like it and good to see your putting it to good use.

Can i ask though did they open the cambers up a little bit if they skimmed the head loads? as this raises the compression?
 

·
Registered
Joined
·
1,602 Posts
Dont care how many people say that bronze is played .. it always looks bad arse.
 

·
Premium Member
Joined
·
2,596 Posts
Discussion Starter #67
Time to find out what that annoying ticking noise was, dreading the cost & effort of fitting a new driveshaft. Found the ticking fairly quick. Too much slack in the brake line meant the wheel weights were catching it on the way round. Good news is that as it's nearly all the way through the line, the noise should go away soon.......

https://flic.kr/p/EpBV8Lhttps://www.flickr.com/photos/lukelloyd/, on Flickr
 

·
Premium Member
Joined
·
2,596 Posts
Discussion Starter #70
Thought some of you might find this pic of me at work interesting. Going backwards round Goodwood at 50mph on a bench seat with a lap belt.

 

·
Premium Member
Joined
·
2,596 Posts

·
Premium Member
Joined
·
2,596 Posts
Discussion Starter #80
Possibly Adam, I haven't looked at it. Tempted by a RWYB although it's nothing special but would just be a good experience going down the strip.

The GT3's are 16's same as my Grids but I've got the Nankangs in 45 profile rather than the 50 I have on the Grids and think it looks better. Ride quality is noticeably poorer however, I wouldn't want them on every day of the week though think that could be in part to the super stiff sidewall of the Nankangs.
 
61 - 80 of 463 Posts
Top